Owner manual

111
1. Press the ON LINE/MENU key to place the printer Off line.
2. Press the FEATURE çç key until the ‘Software Rev.’ feature is displayed.
3. Press the ENTER key.
4. Press the FEATURE èè key to display the following features.
CAUTION: Only qualified users/service technicians
should select this menu.
Feature
Values Description
Output Bin Override
##
0 to 50 After the OUTPUT BIN sensor detects a
full condition it will accept an additional
number of coupons (set here) before a full
condition is shown on the LCD.
Reject Bin
Override ##
0 to 15 After the REJECT BIN sensor detects a
full condition it will accept an additional
number of coupons (set here) before a full
condition is shown on the LCD.
Profile Lockout Enabled
Disabled
This feature enables or disables the four
Profile Select keys.
Calibrate Sensor N/A This feature will calibrate the coupon
detection sensors. To run this test, you
must first place a stack of 50 flat
coupons in the REJECT BIN and a stack
of 190 flat coupons in the OUTPUT BIN.
N: ##, G: ##, P: ##,
P: ##, H: ##
N/A Feature displays first five sensor values.
E: ##, O: ##,
RB: ##, OB: ##
N/A Feature display next four sensor values.
Mag Calibration N/A This feature is used to calibrate printer
magnetics when excessive magnetic verify
errors occur or a new type of ticket stock
is used.
B1: ###, ####:
B2: ###, ####
N/A This feature displays the mag calibration
values for BIN 1 and BIN 2.
Aux Port: COM 2
LPT1
Selects the type of auxiliary port.
Auxiliary Port Test N/A This feature is used to transmit a test
pattern out of the COM2 (itinerary printer
port) serial port. Press the ENTER key to
initiate the test.
Feature Values Description