User`s guide

3.1.1-2.1 Darkness:

36
Use this option to setup printing darkness. The available setting is from 0 to 30, and the step is
1. Printer default density is 16.You may need to adjust your density based on selected media.
Press
and to increase/decrease the printing darkness. Press
key to enable the setting. Press
key to cancel the setting and return to the
previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.
3.1.1-2.2 Print Speed:
Use this option to setup print speed. The each increment/decrement is 1 ips.
Press
key to raise the print speed, and press key to decrease print speed.
Press
key to set it into printer. Press key to cancel the setting and
return to the previous menu.
Note: If printing from enclosed software/driver, the software/driver will send out the
command, which will overwrite the setting set from the front panel.

3.1.1-2.3 Tear Off:
Dankness
16
Print Setup 1/17
> Darkness
Print Speed
Tear off
Print Speed
6
Print Setup 2/17
Darkness
> Print Speed
Tear Off
Print Setup 3/17
Darkness
Print Speed
> Tear Off
Tear Off
+000
This option is used to fine tune media stop location. Press the
button to move the
cursor from left digit to right digit, and press the
button to set the value from “+” to “-” or