Owner's manual

Following is an example of some common forms used and specific features that may be

programmed into a profile when using these forms. For more information refer to Section

3.13 “Selecting Paper Paths Using The Profile Key”.

Profile Name/Feature Value

Feature Name P1

"Report"

"Invoice"

"Checks"

"Statements"

Form Length 88 66 24 30

Lines/Inch 8 6 6 6

Right Margin 136 80 70 70

Horz Adj 0/144 5/144 8/144 12/144

Manual Tear FF TOF TOF TOF

Emulate IBM PRO IBM PRO LA 120 LA 120

Font DP 18 Draft 10 OCR A Draft 10

Parallel Enable Disable Disable Enable

Path Main Either Alternate Alternate

In this sample, to change from printing "Report" to "Checks" do the following:

1. Take printer off line by pressing the On/Off Line key.

2. Park current form.

3. Change to the desired profile, in this case "Checks".

4. Load the appropriate forms ("Checks").

5. Place unit on line.

The Path feature specifies which paper path is selected. Profile 1 named “Report” selects

the main path. Selecting Profile 2 leaves the path unchanged. Selecting Profile 3 and 4

selects the alternate path.

For an application that is not stored in a profile, call up the profile whose features most

closely match the application and reprogram only the features requiring change. These

changes will not alter the profile's permanent settings unless you save them when you exit

Setup Mode.

4-2

4.3 Setup Mode Key Functions

To change features, open the Keypad Door to enter Setup Mode. Figure 4-1 shows the

Setup Mode keys and their respective functions.

A brief description of each key function follows.