Owner's manual

ESC 5 Cancel italic character set
ESC 6 Enable upper character set (80 hex to 9F hex and FF hex).
ESC 7 Enable extended control codes (Turns off ESC 6).
ESC 8 Disable paper out detector
ESC 9 Enable paper out detector
ESC : Copies resident characters (ROM) to RAM
ESC < Enable one line unidirectional printing
ESC = Set MSB to 0 (Sets 8th bit low)
ESC > Set MSB to 1 (Sets 8th bit high)
ESC ? Reassign graphic codes
ESC @ Resets printer
ESC A Set line spacing to n/72 inch
ESC B Set vertical tabs
ESC C Set forms length in lines
ESC C Set forms length in inches when first variable is a null
ESC D Set horizontal tab
ESC E Select emphasized printing
ESC F Cancel emphasized printing
ESC G Select double-strike printing
ESC H Cancel double-strike printing
ESC I Enable/disable printing of characters stored in the lower control code area
00hex to 31 hex)
ESC J Perform an immediate line feed of n/216 inch
ESC K Select single-density graphics
ESC L Select double-density graphics
ESC M Select Elite (12 cpi) mode
ESC N Set perforation skip to n lines
ESC O Disable perforation skip mode
ESC P Select Pica (10 cpi) mode
ESC Q Set right margin
ESC R Select international character set
ESC S Select Superscript or Subscript characters
ESC T Cancel Superscript or Subscript characters
ESC U Select/Cancel Unidirectional print mode
ESC W Select/Cancel Enlarged print mode
ESC Y Select high speed double-density graphics
ESC Z Select quadruple-density graphics
ESC ^ Select 9-pin graphics
ESC b Set up vertical tabs for Vertical tab channel c
ESC l Set left margin
ESC j Perform an immediate reverse line feed of n/216 inch
ESC k Select NLQ Typestyle
ESC p Select/Cancel Proportional printing
H-2