Owner's manual

C.6 Menu 6 Parallel Interface
Feature Default User P1 User P2 User P3 User P4
Handshak On Busy
Ack before Busy
8th Bit Enable
Parallel Enable
C.7 Menu 7 Profile Control
Feature Default User P1 User P2 User P3 User P4
Rename: Profile 1
Save Profile ******* ******* ******* *******
Reset Profile ******* ******* ******* *******
Ser Port Off
Par Port Off
Port Time 8s
Max Profiles 10
*** These features cannot be user defined.
C.8 Menu 8 Form Thickness Control
Feature Default User P1 User P2 User P3 User P4
Auto Form Gap xxxx xxxx xxxx xxxx
Quiet/HIGH
Adj. Form Gap 36
Hor Gap Pos 2.0"
VR Gap Pos 1.0"
C.9 Menu 9 Diagnostics
Feature Default User P1 User P2 User P3 User P4
Print Profile ******* ******* ******* *******
P/N: ###### xx ******* ******* ******* *******
Test Printhead ******* ******* ******* *******
Run Mode Test ******* ******* ******* *******
Alignment Tst 5 ******* ******* ******* *******
Run Self Test ******* ******* ******* *******
*** These features cannot be user defined.
C-3
To change these settings, follow the direction in Chapter 4 "Features". It is suggested that
the user execute the "Print Profile" feature for each used profile and enter each altered
value into the applicable default table or attach it to this manual.