Owner's manual

Symptom Corrective Action
Printhead Pauses At End Of Print
Lines
Printhead thermal protection is activated. Make sure printer has
proper air flow and is not located in an excessively hot area.
Printer will exit this mode automatically after cooling.
Printer Will Not Switch Paths Change the Path Value to "Either" under M2 Forms Control.
(See Sections 3.9 - 3.14)
First Print Line Location Is Wrong Readjust the first print line using the instructions in Section 3.5.
Park and reload.
Print Contrast On Last Sheet Is Too
Light
Verify that the forms thickness setting is correct for the form
being used.
Enable the Double Strike feature under M4 Printer Control.
(See Sections 4.6 - 4.7)
Select an NLQ Font listed in Section 3.5.
Printer Is Too Noisy Enable Whisper/LOW feature under the M8 Forms Thickness
Control Menu. (See Sections 4.6 - 4.7)
5-18
Appendix A.................................... Printer Specifications
A.1 Printer Characteristics