Stereo Receiver User Manual

EXT Control
The EXT buttons provide an insert point in the control voltage signal, after the bias control but before
routing back to the channels.
During normal operation the control voltages generated by the sidechain are internally connected
to the CV Link switched for routing back to the channels. In EXT mode the control voltage is taken
from the rear connector instead of the sidechain outputs, allowing the unit to be slaved from a
second 8051 or 33609.
-
There is no EXT Control with 88R(S) console mounted compressors (AM5052 & AM5265).
Pin Function
1 0V Reference
9 CV send, sidechain A
12 Remote power-on
5 CV send, sidechain B
13 CV return, sidechain B
14 CV return, sidechain A
15 24V Reference
Short to pin 12 to pin 1 to take the unit out of standby mode remotely.
8051 5.1 Compressor User Guide
Issue 2 Page 9
PUSHPUSHPUSHPUSHPUSHPUSHPUSH
INPUT 1
OUTPUT 1OUTPUT 2OUTPUT 3OUTPUT 4OUTPUT 5OUTPUT 6
INPUT 2INPUT 3INPUT 4INPUT 5INPUT 6KEY INPUT
CONTROL
VOLTAGE I/O
PLEASE SEE
MANUAL
CHASSIS INTERNAL
0V
FUSE 1.6A A/S CERAMIC
INPUT VOLTAGE 100-250V AC
INPUT FREQUENCY 47-63Hz
WARNING
DISCONNECT MAINS LEAD
TO ISOLATE UNIT.
NO USER SERVICEABLE
PARTS INSIDE
HAZARDOUS VOLTAGES INSIDE
REFER TO MANUALS