User manual

Glide Times
Allows users to adjust Glide rates for Match and Auto Match modes.
Current Desk Setup and I/O Config
This shows the names of the currently loaded Desk Setup and I/O Configuration files.
Current Play and Record Pass
The green numbers show the current Play Pass that will be used for play back when timecode is running. The
Record Pass is only shown when a Record Pass is being made or when Manual Keep is active and the Record
Pass has not been kept.
Timecode
Shows the current timecode (running or stopped).
Transport Control and Status Indication
Used to control and show the current status of the primary transport controller. The icons are functionally
identical to the matching keys on the console surface. The icons change to a lighter colour (so that they seem to
illuminate) to show the transport status.
Status Bar
The Status Bar shows:
Timecode Format
The current type of Timecode that is being received or being generated by Logic MMC.
Sample Rate
The current sample rate being used by the system.
Sync Source
This indicates whether the current source of the synchronisation timing signal is internal or external.
Keep Mode
This shows whether the Keep Mode for new Record Passes is Auto or Manual. If it is Auto then a new Record Pass
will automatically be saved to the Mix/Pass Tree when timecode stops. If it is Manual then a new Record Pass will
only be saved when timecode is stopped and the KEEP MIX key is pressed.
Offset
This shows the current timecode offset used by the automation system. This is the difference between the
timecode in use by a transport device and the timecodes at which dynamic events will be played back and/or
recorded.
Using Encore The Main Encore Screen
Issue 4 Page 17:2