User manual

If ALL/SCOPE is held down when TO END is pressed then the whole Pass will be overwritten to the beginning of
the pass.
Setting Automation Modes for Controls
The Mode button by each logicator sets the automation scope for each control (either Play, Rec, Glide, Isolate,
Etc.), and also sets snapshot and linking scope.
ä
To set the automation mode for a control, press and hold the Mode button adjacent to that control, and
select the automation mode using the fader Play, Rec, and Glide automation buttons.
ä
To place the entire process into an automation mode, press and hold the PROCESS key at the bottom of the
panel and set the mode using the fader automation buttons.
If there are controls in that process that already have an automation mode, then the first press will isolate all
controls, the second press will add all controls.
ä
To place all the available controls for a path into an automation mode (including the On/Clear), hold the
Access key for that path then use the fader Play and Rec buttons to select the appropriate mode.
Making a Mix/Pass
The steps required to make a new Mix/Pass are:
o
Switch on the Automation System or press the RUN key on the console surface
o Start a New Mix/Pass Tree
o Move controls to their starting values
o Set Automation Modes
o Put the System into Play
o Make control moves and change Automation Modes as required
o Take the System out of Play and Keep the Record Pass
These steps are summarised in the Making Mix/Passes diagram:
Automation Making a Mix/Pass
Issue 4 Page 16:9
Automation Mode
On
Create or Load
Mix/Pass Tree
Name and create a
New Mix/Pass Tree
(system takes an Initial Snapshot)
Select a Play Pass
(transferred to
Console automation memory)
Set initial control positions
and Automation Modes
Put the System into Play
(a Safety Snapshot is taken on
pressing Play)
Stop the system
(Timecode not at Play speed)
Keep the Record Pass and add
it to the Mix/Pass Tree
(replace the Play Pass with the Record
Pass in Console automation memory)
Record Pass
not kept
Create
Load
Keep
Don't
Keep
Record next Mix/Pass or
Select a different Play Pass or
Start a New Mix/Pass Tree
Control moves and
changes to Automation Modes
Initial Snapshot
New Record Pass
updated by taking controls
out of Isolate,
created by changes
to Automation Modes,
Initial Snapshot updates
and/or recording Events