User manual

Automation Scope
Scope is used to determine whether or not a control can have its automation mode changed by the Master
Automation controls.
The current Automation Scope is part of the Mix/Pass. If no other actions have or would cause a Record Pass to
be created then changing Automation Scope creates a Record Pass (when the system goes into Play or if it is
already in Play). Changes to Automation Scope are not saved unless the Record Pass is saved.
Fader, Cut and Desk Scope
Any control that is not in Isolate is in Scope unless the DESK AUTO, CUT AUTO or FADER AUTO keys have been
toggled off.
ä
To toggle Faders in and out of control Scope press the FADER AUTO key.
Faders (not in Isolate) are in Scope if the LED above the key is illuminated.
ä To toggle CUT keys in and out of control Scope press the CUT AUTO key.
CUT keys (not in Isolate) are in Scope if the LED above the key is illuminated.
ä To toggle all other controls in paths in and out of control Scope press the DESK AUTO key.
Controls not in Isolate will be in Scope when the LED above the DESK AUTO key is illuminated.
Putting Controls in Scope
ä To place all controls in Scope (including those in Isolate) press and hold the ALL/SCOPE key then press the
Master Automation key(s) for the required Automation Mode.
All controls will be put into the selected Automation Mode.
If any of the DESK AUTO, CUT AUTO or FADER AUTO keys have been toggled off then the appropriate set of
controls will be unaffected.
ä
Release the ALL/SCOPE key.
If a Trim mode is selected, only the Faders will have their Automation Mode changed.
ä
Now use the Master REC, PLAY, TRIM and GLIDE keys to change the Mode of controls in Scope (i.e. without
using the ALL/SCOPE key as well).
If the Master ISOL key is pressed then all controls in scope will be Isolated and taken out of scope.
ä
To place controls in a path in Scope without changing the Automation Mode toggle the state of the DESK
AUTO, CUT AUTO and FADER AUTO keys as required.
ä
Press and hold the ALL/SCOPE key then press the required ACCESS key.
All controls in the path will be put in Automation Scope, except those excluded by the DESK AUTO, CUT AUTO
and FADER AUTO keys.
The current Automation Modes of controls will remain unaffected. Release the ALL/SCOPE key.
The ACCESS keys for as many paths as necessary can be pressed while the ALL/SCOPE key is held down.
Automation Automation Scope
Issue 4 Page 16:4
REC
AUTO
TOUCH
ISOL
PLAY
RUN
ALL/
SCOPE
TO
END
DESK
AUTO
FADER
AUTO
MASTER AUTOMATION
TRIM GLIDE
CUT
AUTO
COLLECT
TOUCH
MASTER
TOUCH
ISOLATE
KEEP
MIX
MASTER
TOUCH
RECORD