User manual

Both the mode keys and the process keys will illuminate red to show when that element is included in scope.

Once the scope has been set, press and hold the Access key on the source path then press the Access keys for

those paths to be included in the link.

The relevant process keys and mode keys will light to show that it has been included in the link.

To add an offset between linked elements:

For controls - hold the SHIFT key and adjust the required control.

For faders - hold any other fader in the link, then adjust the required fader.

Press KEEP DESK to ensure that the links are saved with the desk setup.

Copying Control Values

This allows the user to copy control values and switch states between paths.

Press the COPY key.

The alphas will flash 'Copy' then press the Access key for the path you wish to copy values from. The scope

defaults to include all controls including faders and mutes, so all available mode and process keys will

illuminate red.

ä When you now press either Mode keys (for individual controls) or Process Keys (to include all controls in that

process), it is possible to reduce the scope to nothing and add elements in.

ä To add/subtract faders and mutes, use the Fader Mode and Cut Mode keys above the fader.

ä When the scope has been set, hold the Access key for the source path, and then press the Access keys for

destination paths.

Press COPY again to exit Copy mode.

Saving the console configuration with KEEP

The basis of the console configuration is the Desk Setup that is determined with Desk Edit, but also includes the

routing, the order of processing in the paths, the settings on all processing functions for each path and the

assignment of paths to the console surface.

This information is saved to the Encore hard disk in the configuration file that is initially generated with Desk Edit

when a new Desk Setup is started.

In addition to this, the files containing I/O configuration, snapshot and defaults data can be associated with a

Desk Setup, so that when a Desk Setup is loaded or saved the associated information is also loaded.

Ganging Linking Controls

Issue 4 Page 14:2

SHIFT

CLEAR

COPY

PATH

EDIT

KEEP

DESK

RECALL

SNAP

CREATE

SNAP