User manual

Metering

The Routing and Metering Section has sixteen bargraph meters that follow the Bus/Tape switching on the

Tracks.

Two assignable VU (moving coil) meters are also provided.

VU Meters

SEL5 is used for sending a signal to the VU Meters (see System Paths). This allows the SELECT Panel to be used

for signal source selection.

ä To select the signal to be metered by the VU Meters press and hold the ASSIGN key to the right of the meters.

ä Press the MAIN, GRP, AUX or EXT key on the SELECT Panel.

The integral LED will illuminate red.

Then press the key for the required path number.

Available paths are indicated by keys with the integral LEDs illuminated green. The LED in the selected key will

illuminate red and the selected path will appear in the alpha display next to the ASSIGN key.

Source selection for the VU Meters is interlocked (i.e. the previous source will be de-selected automatically).

Metering VU Meters

Issue 4 Page 11:1

15 165

21 24

2523201918 26

28 29 30 31 32

17 22

-10-10-10-10-10-10-10-10-10-10-10-10-10-10-10

-10

-20-20-20-20-20-20-20-20-20-20-20-20-20-20-20

-20

-40-40-40-40-40-40-40-40-40-40-40-40-40-40-40-40

-60-60-60-60-60-60-60-60-60-60-60-60-60-60-60-60

0000000000000000

REC

ALL

REC

ALL

SAFE

RECRECRECREC

RECREC

RECRECRECRECRECRECRECRECREC

MAIN OUTPUT ROUTE

ASSIGN