User manual

To select the speakers for monitoring a stem press the A-F key on the Stem and Recorder Control section for

the required stem.

Then press and hold the required speaker key on the Surround Monitoring section and press the 1-8 keys on

the Stem Control panel with a Track (bus) which has the correct Pan Designation.

The integral LED in the number key will turn red or orange flashing according to whether or not the Stem is

selected for monitoring on the STEM SEL section of the Surround Monitoring Panel.

Release the speaker key. Continue to select Stem elements to the speakers.

This can also be done in reverse:

Press and hold the number key then press the speaker key.

The speaker select key LEDs will be illuminated according to the FILM type in the current Desk Setup. E.g. If four

way surround sound (LCRS) is selected, the L, C, R and LS key LEDs will illuminate.

It is possible to use Stems for 'narrower' surround formats than the Desk Setup has provided with the number of

Film paths. For instance, an LCRS Stem can be monitored on a 5.1 monitoring setup by routing the rear

surround channel to both the left and right surround monitors.

ä To route inputs to the Stem press and hold the Access key for the required Channel then press the keys above

the routing screen for Tracks in film stems.

The LEDs in the Track keys will illuminate red.

Release the Access key and inspect the PAN panel.

The green LEDs above the ON/OFF keys for each pan control illuminate to show which panners are currently

selected.

Press the ON/OFF keys for the pan controls so that the required panners are selected.

Surround Sound Panel Surround Stem Selection and Routing

Issue 4 Page 9:4

5.1 Format Surround Sound Example:

Select the speakers for monitoring the Stem

Press and hold the 1 key on the Stem and Recorder Control section and press the L

key on the Surround Monitoring section of the Surround Sound panel.

The LED in the L key will change from green to either solid red or flashing orange,

depending on whether or not Stem A is currently selected to the Monitor outputs.

ä Release the 1 key and repeat in sequence for the remaining Stem members (i.e. 2

on C, 3 on R, etc.).

It is also possible to do this routing in reverse:

ä Hold down a speaker key and select which track in a Stem is routed to it.

5.1 Format Surround Sound Example:

Select inputs to the Stem

Press a Layer key, this will bring inputs 10, 11 and 12 to the surface.

On Channel 10 press and hold the Access key and press the keys above the

routing screen corresponding to Tracks 1 to 8.

The LEDs in the Track keys will illuminate red.

Release the Access key.

The green LEDs above the ON/OFF keys for each pan control illuminate to show

which panners are currently selected.

Press the ON/OFF keys for the pan controls so that all panners are selected.

All panning controls are now enabled.

Rotate the Logicators to pan the signal as required, repeat the steps for Channels

11 and 12.