User manual

Studio Loudspeakers
ä
To select the signal source for the studio loudspeakers press and hold the SELECT key for the Studio L/S then
press the MAIN, GRP, AUX, CUE or EXT key on the SELECT Panel.
The integral LED will illuminate red.
ä
Press the key for the required path number.
Available paths are indicated by keys with the integral LEDs illuminated green. The LED in the selected key will
illuminate red.
The selected path will appear in the alpha display for the Studio L/S. Source selection for the headphones is
interlocked (i.e. the previous source will be de-selected automatically).
ä
Release the SELECT key.
Bus and Tape
Bus/Tape switching only applies to the Tracks and controls the input signal to the path. This is shown on the
Track Signal Path Schematic.
The status of the Bus/Tape switching on the Tracks will affect the audio that is heard on any of the monitoring
destinations that Tracks are routed to. Tracks are switched to Bus by default for new Desk Setups.
ä
To create a mix of bus and tape (e.g. for over-dubbing) press both the BUS and TAPE keys at the same time.
The integral LEDs in both keys will illuminate.
The signals from the Bus input and Tape input will be summed before any signal processing in the path is
applied. This is useful for introducing new material over finished material that has been previously recorded.
The ALL BUS and ALL TAPE keys globally switch all monitor paths.
Monitoring Studio Loudspeakers
Issue 4 Page 8:4
STUDIO LSHEADPHONES
SEL1SEL2
**
TALK
TALK
CUT
DIM
SELECT
SELECT
Input
Port
Multitrack
Output
Port
TAPE
switch
BUS
switch
output
mix
bus
Film Monito
r
Main
Track
Group
input
mix
bus
Channel
Track
Group
Track
Send
Track
Return
input
routing
matrix
output routing matrix
and
film stem configuration
PRE/POST
Switch
ON/OFF
Switch
Aux
Path Processing
(Fader, EQ, Dynamics, etc.)
TAPE
INPUT
BUS
INPUT