User manual

ä
To mute the output to the speakers press the CUT key.
The integral LED will illuminate orange. This cuts the output to all three sets of speakers.
ä
To reduce the output level to the dim level press the DIM key.
The integral LED will illuminate orange and the level of the output to the three sets of speakers will be reduced to
the Dim Level setting on the Monitoring page of System Preferences.
ä
To listen to a mono mix press the MONO key.
The integral LED will illuminate orange.
ä
To listen to M/S encoded output press the M/S key.
The integral LED will illuminate orange and the main (mono sum) will appear on the left speaker and the
difference (side) on the right speaker.
ä
To reverse the phase of the output press the PHASE LEFT and/or PHASE RIGHT keys as required.
The integral LED will illuminate orange.
ä
To cut the output to the left and/or right speakers press the CUT LEFT and/or CUT RIGHT keys as required.
The integral LED will illuminate orange.
ä
The listen at a pre-selected calibration level press the CAL key.
The integral LED will illuminate orange and the -3, -6 or USER indicator will illuminate as appropriate.
The keys on this panel (except SOLO CLEAR) can operate in two ways;
ä A brief press of the key will turn the key on and then another brief press to turn it off. Pressing and holding a
key causes the key to remain on until it is released.
Headphones
There needs to be at least 4 SELs in the Desk Setup for the headphone output to work.
ä
To select the signal source for headphones press and hold the SELECT key for the headphones then press the
MAIN, GRP, AUX, CUE or EXT key on the SELECT Panel.
The integral LED will illuminate red.
ä
Press the key for the required path number.
Available paths are indicated by keys with the integral LEDs illuminated green. The LED in the selected key will
illuminate red and the selected path will appear in the alpha display for the headphones. Source selection for
the headphones is interlocked (i.e. the previous source will be de-selected automatically).
ä
Release the SELECT key.
ä
To inject talkback onto the headphones output press the TALK key.
The operation of the TALK key depends on the setting in Tone & Talkback Preferences.
Monitoring Headphones
Issue 4 Page 8:3
STUDIO LSHEADPHONES
SEL1SEL2
**
TALK
TALK
CUT
DIM
SELECT
SELECT