User manual

Press the keys for the required sources at the bottom of the screen or the numbered GROUP keys then

release the destination key.

The Auxiliaries can only be selected as destinations, not as sources.

To route multiple sources to Groups, Main Outputs or Auxiliaries press and hold the required number key in

the GROUP, AUX or MAIN OUTPUTS area.

Existing sources will be indicated by the screen, source key LEDs and ACCESS Key LEDs.

Press the keys for the required sources then release the destination key.

To access additional Tracks (if available) press the left/right arrow keys above the screen.

The red hashing will move to the next/previous row of Track numbers.

Path Routing with the Access Keys

The ACCESS Keys on the Fader Strips, can be used for routing, either by using other ACCESS Keys or any of the

routing controls associated with the Routing Screen. When an ACCESS Key is used for routing a Track then it can

only be used as a routing source.

To route a path to destinations press and hold the ACCESS Key or main output for a Channel or Track Group

then press the keys for valid destinations on the routing screen or other Access Keys.

Existing routing of the path will be indicated by the illumination of LEDs above ACCESS keys and integral LEDs

in the keys around the Routing Screen illuminating red.

The integral LEDs in the keys for the selected destinations will illuminate red and the Routing Screen will show

routing changes.

Clearing Routing

Clearing routing (or de-routing) can be achieved by the same actions as doing the routing (to toggle the

particular routing selection off again). This will de-route paths one at a time. Alternatively, multiple paths can be

de-routed in one operation by using the Clear Routing dialogue box.

To clear routing press the left and right arrow keys above the routing screen at the same time or right click on

the routing screen.

Click the Clear Routing option.

In both cases, the Clear Routing dialogue box will be displayed.

Click in the required Source and Destination check boxes and click OK.

The selected routing will be cleared (de-routed) and the routing screen will be updated as applicable.

Clear Routing does not affect monitoring selections made via the SELECT Panel.

Routing Path Routing with the Access Keys

Issue 4 Page 7:6