User manual

Route Mode

The ROUTE MODE key on the upper channel strip sets the automation mode of the selected stem.

Press and hold the key, then press the appropriate automation key on the lower panel above the appropriate

fader to change the mode.

Route Stem

The ROUTE STEM key on the upper channel strip routes the path to stems.

If the path is routed to all tracks in the stem, then first press will deroute everything.

If the path is routed to some of the tracks in the stem, first press will route to all tracks and second press will

deroute to all tracks.

If the path is routed to none of the tracks in a stem, first press will route to all tracks.

Interrogating I/O Routing

The input and output port routing (or patching) can be shown on the electronic scribbles on the Fader and

Master Fader Strips.

To show I/O routing (patching) press the SHOW PATCH key in the Faders Global Control Panel.

The LED above the key will flash. The electronic scribbles will show the system name of the inputs to the paths

assigned to the faders. Blank scribbles indicate no input port is routed (patched).

ä Press the SHOW PATCH key again.

The electronic scribbles will show the system name of the outputs from the paths assigned to the faders. Blank

scribbles indicate no output port is routed (patched).

If a Main Output has more than one output, only the first will be shown.

Press the SHOW PATCH key again.

The console will return to its normal state.

The FLIP key on the fader strips, the Bank keys and the Layer Selection keys can be used while SHOW PATCH is

active to view the porting for the paths that they assign to the faders.

Routing Interrogating I/O Routing

Issue 4 Page 7:2

AUX2

FADERS GLOBAL CONTROL

ALL

TAPE

COALESCE

TRIM

ALL

AUX

SHOW

PATCH

ALL

BUS

GANG/

LINKS

SUB