User manual

Studio Configuration Page

This will show a list of configurations that are available on the selected drive or disk.

Click on the required configuration name in the list.

It will be highlighted and the name will be shown in the Configuration to restore box.

Click the Transfer File button.

The Studio Configuration will be imported and will now be used to define the hardware available to Desk

Setups.

Snapshot Scope

Snapshots allows the user to set up two independent scopes - one for Create Snap, one for Recall Snap. Both of

these scopes are remembered on each entry/exit to snapshots, and also remembered with the desk setup.

ä To set the scope to include all elements, press REC on the Master Automation Section.

All available controls and processes will show red, as if in touch.

To set scope to exclude all elements, press ISOL on the Master Automation Section.

All available controls and process LEDs will extinguish.

By default, both scopes are set to include all controls for all available processes, including faders and mutes.

This type of scope setting is called subtractive, as touching controls or process buttons will remove those

elements from scope.

If you were now to press ISOL on the Master Automation Section, then the scope is reduced to nothing and

setting the scope becomes additive, where touching controls or process keys will add that element into

scope.

To copy scope between paths, press the Master Panel Access key.

The led will start to flash to indicate that the Copy Scope function is now active.

Press and hold the Access key on the source path, then press the Access keys for destination paths.

Press the Master Panel Access key to end the copy function.

To keep both scopes with the desk setup, press KEEP DESK in the Utilities section.

To set the Scope for a Snapshot press the CREATE SNAP (or RECALL SNAP) key.

Tools Menu Snapshot Scope

Issue 4 Page 24:42