User manual

On the ports list, double click each level of the tree to show the available ports on that rack. Before you port

the machines, first ensure that if there are inputs displayed on the left as shown above, then the window on

the right must be set to display Outputs (outputs from the desk are inputs to a machine, and vice versa)

otherwise ports will not be applied.

Highlight the selection to be applied by clicking on the first port, then holding Shift and clicking the last port

to highlight a selection. Drag and drop this on the first path where you wish to start your porting from.

In the example above, the four AES inputs have been ported to the first four outputs on the Avid.

Be aware that when ports are applied, unlike I/O Manager, Encore does not warn you that an Output port may

already be in use.

I/O Patch can also be launched from machine Manager, either by selecting it from the Machine menu, or

clicking on the I/O Patch icon on the icon bar at the top of the screen.

ä To set the relays for a machine, call the desired machine to the right hand window and click Relays

underneath (this option will be unavailable if the Relay field is set to None).

From the Relay Type pulldown menu, select the type of relay.

Double click on the words Not Connected, and a dialogue box will open.

Enter the number of the relay. If you hit Return on the keyboard, the highlight bar will drop to the next path

and increment the value by one.

The + & - buttons at the end of the field can be used to increase or decrease the relay number. If you try to assign

a relay that is already in use, you will be warned of this before any re-assignment takes place.

To clear ports or relays, highlight the selection to be cleared by clicking and dragging, then press Clear.

Clearing Outputs will not clear Input porting and vice versa.

EDL Editor

This option is currently unavailable.

Tools Menu EDL Editor

Issue 4 Page 24:33