User manual

The SRC Configuration page shows AES cards which are installed in the system and allows the SRC Mode and

State to be modified.

The SRC State may only be modified when a suitable Mode has been selected.

SRC Mode

Shows the current mode of SRC on the port and is used to enable and disable SRC.

The mode is selected from a drop down list.

The modes available depends on the card type:

820A154 No SRC

820-154 No SRC or

USRC (Universal SRC)

820-091 No SRC or

SSRC (Synchronous SRC)

To set SRC Mode double click in the Mode column for the required AES port.

A small drop down list will appear with an X next to it.

Double click on the required Mode.

The new Mode will be displayed in the column.

If the resources on a particular card have been used up then the system will prevent attempts to enable SRC on

more ports.

SRC State

Shows the current state of SRC on ports with SRC Mode selected.

Used to select the output rate from a drop down list.

The options available depend on the card type:

820-154 Cards

Input ports will have SRC On or Off according to the SRC Mode selected (i.e. the State is set automatically by

Mode).

Tools Menu I/O Config

Issue 4 Page 24:20