User manual

A box will appear with an X next to it.

Enter the amount of Delay from the Encore keyboard and press ENTER on the Encore keyboard.

Auto Increment and Auto Copy can be used when entering delay times.

To automatically configure Delay on multiple ports click in the Delay column, click and hold the trackball

button on the first Delay entry to be configured, drag down the range of ports to configure, release the

trackball button and click on the Auto Configure Delay button.

The delay Remaining will be divided equally amongst the highlighted ports leaving a remainder which will be

the new Remaining amount.

Any Delay already assigned to the selected ports will be added to the Remaining amount before it is divided up.

Dither

This allows noise to be added to an Output port so that the noise content of a signal is redistributed over the

whole frequency spectrum to eliminate noise peaks.

Dithering is 16, 18, 20 or 24-Bit with an LSB Rounding, Rectangular or Triangular pattern.

To set Dither on Output ports click on the Outputs radio button.

The list will show Output ports.

Click on the Type radio button as required and double click on the Dither entry for the required port.

A drop down list of Dither settings will appear.

Double click on the required setting.

Auto Increment and Auto Copy can be used when setting dither.

Relays

When a Relay is associated with an Input port, the Relay is closed when the fader is above -60dB.

When a Relay is associated with an Output port, the Relay is closed by Rec Enable.

To associate a Relay with a port double click on the in the Relay column for the required port.

An entry box will appear with an X next to it.

Enter a valid Relay Number using the Encore keyboard and press ENTER on the Encore keyboard.

The number will be shown in the Relay column.

Auto Increment and Auto Copy can be used when associating Relays with ports.

To configure Sample Rate Conversion click on the SRC Configuration tab.

Tools Menu I/O Config

Issue 4 Page 24:19