User manual

If Auto Copy is enabled then the text entry box will contain the last Number entered.
ä
To cancel selection or exit from Auto Increment mode click on the X at the side of the box.
To make a port Mono or Stereo
The ports are assigned in pairs to make a stereo input or output.
Adjacent odd and even ports make a stereo pair (e.g. A and B on LIN ports, an odd numbered port and the
following even numbered port on MADI ports, etc.).
The ports will follow the paths if they are not specifically set (i.e. a pair of mono ports assigned to a stereo path
will be treated as a stereo pair).
ä
To make a port Stereo click on a mono port.
The Mono/Stereo radio buttons will indicate Mono.
ä
Click the Stereo radio button.
The second port of the pair will be removed from the list.
The first port will be renumbered with a trailing S to indicate stereo (e.g. 1LIN 1A will become 1LIN 1S).
The system name in the Ports column will be displayed in red.
ä
To make a port Mono click on a Stereo port and click on the Mono radio button.
To Clear Settings
Clearing a setting resets it to the system default and the entry will change back to -- or 0.
ä To clear a single setting click directly on the required entry and click the Clear button.
ä To clear all settings for a single port click on the System Name of the required port in the Ports column and
click the Clear button.
ä To clear all settings for multiple ports click and hold the trackball button on the first System Name of the ports
to be cleared, drag down the list until the last port to be cleared is selected, release the trackball button and
click the Clear button.
ä
To clear multiple entries in a single column click in the column containing the entries to be cleared, click and
hold the trackball button on the first entry to be cleared, drag down the list until the last port to be cleared is
selected, release the trackball button and click the Clear button.
Delay
ä
To set Delay Units click on the Delay Units button.
A dialogue box will appear containing the options for Delay Units.
ä
Select the required units and click OK.
The legend on the Delay Units button will change to indicate the selected Units.
The Remaining amount will display the amount of Delay left to assign in the new Units.
Any Delay configured will change to show the setting in the new Units.
ä
To configure Delay on single ports double click in the Delay column for the required port.
Tools Menu I/O Config
Issue 4 Page 24:18