User manual

To change an I/O Port click the Port State check box so that there is no X in it.

This turns off the selected port.

Click the AES, AFT, LIN, MADI or SDF radio button as required then click the drop down arrow next to the

port name. Scroll through the port list and click on the required port name then click the Port State check box

so that there is an X in it.

If an output is selected that is already in use by another path then a confirmation dialogue box will be displayed

to re-assign the port.

If the Disable Output Route Overwrite Warning check box is checked then the confirmation dialogue box will not

be displayed and the path that was originally ported to the output will be de-routed transparently.

I/O Patching

I/O Patching is used to rapidly configure input/output routing.

The number and availability of different path types will depend on the Desk Setup (which can be modified with

Desk Edit).

The number and availability of input and output ports will depend on the hardware setup.

To access I/O Patching click on Tools in the Encore menu bar.

To assign and de-assign Ports to Paths (I/O Routing) click on the tab for the Path Type you wish to route.

The selected I/O routing page will appear.

Routing Inputs and Outputs

To route an Input Port to a Path click on the In column for the required Path.

Click on the required Port in the Ports list and click the Assign button.

The Port name will be displayed against the Path in the In column.

If Auto Increment is enabled then the next Path and Port in each list will be selected.

Click Assign repeatedly to assign sequential Ports and Paths.

To route a Path to an Output Port click on the Out column for the required Path.

The Out column will be highlighted in red.

Click on the required Port in the Ports list and click the Assign button.

Tools Menu I/O Patching

Issue 4 Page 24:14