User manual

When this is complete, a dialogue box will be displayed confirming that the allocation process has finished.
If the Desk Setup is not allocated successfully, the Allocation Results dialogue box will be displayed. This shows
which paths have not been allocated because too much processing has been used. Remove some processing
from those paths and try again.
ä
To save the Desk Setup with a different name click the Save As button.
A Save As dialogue box will be displayed for entering a different Desk Setup name.
Solo Inhibit
If Solo Inhibit is active on a path then the path will NOT be cut when the SOLO key is pressed for another path.
The current status of Solo Inhibits is saved as part of the Desk Setup.
ä
Click on the radio button for the required path type and click the check boxes for the required paths or click
and hold on the first path required and drag the pointer down the list.
Each time a path is selected, the check box will be toggled between checked and cleared. A path is Solo
Inhibited when its check box is checked.
When that path is called to the surface, the red led to the left of the SOLO button will light to indicate that these
paths will remain open when a Solo button is pressed.
Tools Menu Desk Edit
Issue 4 Page 24:9