User manual

Select Paste Range brings up a dialogue box that allows the user to select the destination paths for processing.

In addition, processing can also be 'dragged & dropped' between paths (this also copies it's mono/stereo state

as well).

Assigning Paths to Fader Strips - Desk Designer

Click the Desk Designer tab.

The path assignments made in Desk Designer are stored as part of the Desk Setup. The Desk Designer has 6

banks (4 layers on each).

To assign paths to the console manually

ä To display the required fader scroll the faders to the desired strip using the fader scrolling arrow buttons.

ä In the Paths area click on the radio button for the required path type.

Drag & Drop the path to the required position. A layer on a fader strip can be cleared by dragging and

dropping the path name from the layer box to the path list.

Unassigned paths are shown in black. Paths that are assigned on the current bank are displayed in green and

paths that are assigned to a different bank are shown in red.

Wrapping To Multiple Layers

Wrapping allows the selected paths to be assigned to multiple layers on a specified section of the console from

the Start strip to the Wrap strip.

To wrap onto multiple Layers click the Layer(s) to wrap across.

The paths will always be assigned starting from the first Layer checked.

The Wrap check box will be available when multiple Layers are checked.

Select the paths to assign by clicking and using click and shift to setup a selection. Click the Wrap check box

then click in the Wrap fader strip number box and enter a fader strip number to wrap at.

The remainder of the procedure is the same as above.

It is also possible to rename the banks more appropriately.

Press RENAME, you are allowed names of up to 8 characters.

Press SAVE and LOAD after renaming to ensure the names are kept with the Desk Setup.

Tools Menu Desk Edit

Issue 4 Page 24:4