Installation manual

INSTALLING LOGIC MMC

Important note for customer attention - this could affect your warranty:

It is important that you refer to this document. Information is provided concerning the installation

procedure from unpacking and assembling to powering up the system ready for use.

Failure to follow these procedures and recommendations could invalidate the manufacturer’s

warranty.

Failure to follow these procedures or performing unauthorised modifications to the equipment

could also invalidate compliance to EMC regulations.

Please check carefully the packages you have been supplied. If there is a shortage or evidence that

any item has suffered transit damage then inform the carrier and AMS Neve as soon as possible.

Please note that modules, cards or cables should not be “hot-plugged” (i.e. inserted or removed

with the power on). Hot-plugging can stress the interface components which may lead to failure.

Items returned for repair with this kind of damage are not covered under warranty.

All front panels must be fitted to the racks to achieve the required cooling. If the rack units are

operated with the panels removed overheating will occur and may lead to component failure not

covered under warranty.

Read the following section before starting to power up the system. It is extremely important that the

following checks are carried out prior to switch-on.

Initial Checks

ä Refer to the correct procedures described on the following page when handling static sensitive

devices.

ä Remove the transit packing carefully and check for any signs of shipment damage.

Remove the transit disk from the floppy drive in the 4U Encore Processor Unit.

Ensure all keys on the Keyboard are free from any packing material.

Optional Equipment

Please note that this manual includes all the current options available for a Logic MMC

installation. Custom interconnects when required are included in a separate section - see

contents.

Logic MMC Installation Manual

Issue 5 Page 1