Installation manual

MACHINE CONTROL PORT #2 & #4
ES1–11 Cable (also ES1–12, ES/2, Synchronet)
Location: Rear of SPS Rack
Cabling Information: Use high quality screened twisted–pair cable, paying
careful attention to correct pairing.
A screened twisted-pair cable should also be used
for the XLR connection with the screens connected to
both ends.
Screens should be 360º terminated to EMC backshells
at both ends.
Length as required – recommended maximum 50m.
Logic MMC ES1–11
Machine Control
9 Way D Male
(Jackscrews)
15 Way D Male
(Jackscrews)
Pin Signal Pin Signal
3
Tx+
1
Rx+
8
Tx–
2
Rx–
7
Rx+
3
Tx+
2
Rx–
4
Tx–
4
0v
8
0v
Logic MMC Installation Manual
Issue 5 Page 13