Installation manual

MACHINE CONTROL PORTS #1,#2,#3,#4 and #5
Location: Rear of SPS Rack
Mating connector: DE 9P
Cabling Information: Use a twisted pair screened cable with EMC hoods.
Twisted pairs should be used with Rx–, Rx+ and
Tx–, Tx+ as twisted pairs. The cable screen should be
360º terminated to an EMC backshell at each end.
Pin No. Signal
1
GND
2
RX–
3
TX+
4
GND
5
RTS
6
GND
7
RX+
8
TX–
9
GND
Logic MMC Installation Manual
Issue 5 Page 11