User's Manual

MANUAL FOR SYSTEM INTEGRATOR
80
Both Electronic Bolt and Electronic Strike would have the same wire connection to connect to DP3010R and Open Door Button.
However, the difference for Electronic Bolt and Electronic Strike is in WEB UI configuration. Please refer to following settings.
Configure WEB UI for Electronic Bolt
Configure WEB UI for Electronic Strike
When the wire connection is completed, we
need to select the “Positive” for Electronic Bolt
on the GPIO page of Entrance Setting on
DP3010R WEB User Interface.
When the wire connection is completed, we need
to select the “Negative” for Electronic Strike on
the GPIO page of Entrance Setting on DP3010R
WEB User Interface.