User's Manual

MANUAL FOR SYSTEM INTEGRATOR

4. Installing DP3010R

Now DP3010R is ready to be installed on wall mounting box.

Please follow the steps below to install DP3010R onto wall

mounting box to complete installation.

1. Make sure that the latch on the rear side is at the right

position and would not bump into Iron Plate for Latch.

2. Carefully lift up the DP3010R Main Unit and align it to wall

mounting box.

3. Smoothly let upper Guide Rod and lower Guide Rod slide

into both Slide Guide and firmly push DP3010R Main Unit

toward the wall.

4. Push down DP3010R Main Unit and secure it on the wall.

NOTE: The protective cover on the DP3010R should not be removed

during DP3010R installation. Do not remove the protective cover

until new residents move in the house.

Figure 19: Install DP3010R Main Unit onto Wall Mounting Box