User's Manual

DP3010R VIDEO DOOR PHONE

Figure 15: IO Connectors on the Rear Side of the DP3010R

GPIO (General Purpose Input/Output) & Relay Control

The following table explains input and out put pins of GPIO and Relay Control.

Port definition Description

DI1 (Digital Input port 1) DI1 is used for is used for detecting whether the door is closed

or not. (Or, it is used for PIR.)

DI2 (Digital Input port 2) DI2 is used to connect to indoor “Open Door” button.

DO1 (Digital Output port 1) DO1 is used for external lighting.

DO2 (Digital Output port 2) (Reserved)

CTRL 1 Connect to CTRL 1 on Relay Board to control Electronic Door

Lock.

(-) (GND) Connect to GND

NOTE: 2. For more detailed information, please refer to Appendix A. IO Circuit Application.

NOTE: 1. Pressing RESET

button for about 6

seconds for the device

to restore to its original

factory default.

System will clear all RFID

log, Configuration, and

Number Entry Screen

data.

The network connection

mode of the device will

become DHCP mode.