User's Manual

MANUAL FOR SYSTEM INTEGRATOR

Step 1 Put wall mounting box into wall hole, place a spirit level (bubble level) on the wall mounting box, mark the

four on the wall for drilling holes.

Step 2 Drill four holes for wall screw anchors.

Step 3 Hammer four wall screw anchors into the drilled holes

(Refer to the figure on next page).

Step 4 Remove L-Iron from wall mounting box by loosing screws.

Step 5 Secure four screws and washers to secure the wall

mounting box and secure four screws on L-Irons.

Step 6 Tie four cable ties on the wall mounting box. (Refer to the

diagram on previous page).

Step 7 Again put wall mounting box into wall hole, secure wall

mounting box with L-Irons by securing four screws.

Step 8 Put Hang Rod in the cable ties, tie Hang Rods tightly on

Wall Mounting Box to keep wall mounting box parallel to

the surface of the wall.

Step 9 Again place a spirit level (bubble level) on the wall mounting box, Fasten L-Irons on the wall.

Step 10 Fasten screws to fasten wall mounting box with L-Irons.

Figure 12: Four Marks and Bubble Level