User's Manual

MANUAL FOR SYSTEM INTEGRATOR

Installing Procedures

1. Wall Hole Drilling

Drill a rectangular hole the size of 142mmx 390mm on the wall with its

depth 65~100mm. And, it is suggested that the depth should be 65mm

for DP3010R installation. At the same time, the bottom of the

rectangular hole is at a distance of 1200mm (120cm) above the ground.

NOTE: Reserve the space for junction wiring in the wall.

The junction wiring are for Ethernet cable, DC power, Ground

wire, and Relay control.

Figure 10: Wall Hole Drilling