User's Manual

Video Door Phone User Guide

z Function Name –You may fill out the function for memo.

z Trigger By Digit Input 1 – You can set the “Digit Input 1(DI1)” as a trigger point. You may select the voltage polarity “From High

to Low” or “From Low to High” for triggering.

z Trigger By Digit Input 2 – You can set the “Digit Input 2(DI2)” as a trigger point. You may select the voltage polar “From High to

Low” or “From Low to High” for triggering.

z Ethernet – Some trusted Ethernets can be set up as a trigger point. Please contact with the provider when you need more

information.

z Reporting By Calling Extension Number –You may enable or disable the internal alarm function here. The internal alarm will

also call out to the Video Phone when the Digit Output 2 is triggered. And the Video Phone will get the announcement when it

answers the call. Where the “call out“ number is same as the “Called Party Extension Number” in WEB “Entrance Settings –

Extension” page.

z Time for Alert (Alarm duration) – You can select 3mins / Always for the duration when the DO2 function is triggered.

z Notice Number via Message (SIP) –You may fill in the extension number here, it will send SIP Message to the extension when

the internal alarm is triggered.

z Notice Number via Message (IP :Port) –You may fill in the IP and port for the PC here, It will report to PC when the internal

alarm is triggered

z Device Location : The field allows user to clarify the device location for indication such as “1

Floor West”.

<IMPORTANT>: Please note, all the connection of GPIO MUST be careful. Especially the default polar voltage of hardware (digit

output pins) is high. Please select and set the related electric circuit to meet the hardware initial voltage.