User's Manual

Video Door Phone User Guide
23
internal alarm is triggered.
z Notice Number via Message (IP:Port) –You may fill in the IP and port for the PC here, can also report to PC.
External Alarm (connect with DO4) –Where the external alarm device is connected to the DO4 (Pin : Digit Output 4 ). You may
enable or disable the voltage polarity in the auxiliary DO4. The function can be triggered by the following trigger points. Please refer to
chapter 6.
z Service –You may enable or disable the function.
z Door Bell –The action of pressing the door bell on DP101 can be set as a trigger point.
z Trigger By Digit Input 3 – You can set the “Digit Input 3(DI3)” as a trigger point. You may select the voltage polarity “From High
to Low” or “From Low to High” for triggering.
z Ethernet – Some trusted Ethernets can be set up as a trigger point. Please contact with the provider when you need more
information.
z Device Location : The field allows user to give a device location for identification such as “1
st
Floor West”.
<IMPORTANT>: Please note, all the connection of GPIO MUST be careful. Especially the default polar voltage of hardware (digit
output pins) is high. Please select and set the related electric circuit to meet the hardware initial voltage.
Entrance Settings – GPIO
You may configure GPIO in this page:
Auxiliary Digit Output 2 – Where some external device is (devices
are) connected to the DO2(Pin : Digit Output 2). You may enable or
disable the voltage polarity changeable in the auxiliary DO2. The
function can be triggered by the following ways. Please refer to
chapter 6.
Figure 22 : GPIO setting