User's Manual

Video Door Phone User Guide
22
Hold Version – You may select the version of the SIP Hold service here. There are 2 options: RFC3264/RFC2543. Default is
RFC3264.
Session Timer – You can set the session timer here. The range is from 0 to 1800 seconds. Default is 0 second.
Media Timer – You can set the no continue media string timer here. The DP101 will discard the connection when the condition is
happened. The range is from 0 to 180 seconds. Default is 5 seconds.
No Answer Timer – You can select the disconnection timer when no answer the Doorphone. There are 4 options: 15,30,45 or 60
seconds. Default is 15 seconds.
Entrance Settings – Extension
You may configure call services in this page:
Called Party Extension Number – You may fill out the extension
number assigned from IP PBX. It will dial to the called party extension
number when the Door Bell button is pressed.
Internal Alarm, Alarm will be triggered while stealing –You may
enable or disable the “Stolen Prevention” function. Please disable this
function when the devices are not ready or during the repairing. This
function should be enabled all the time. The default setting is “disable”.
z Service –You may enable or disable the function of “Alarm will
be triggered while stealing”.
z Time for Alert (alarm duration) – You can select the 3mins /
Always for notifying when the internal alarm is triggered.
z Notice Number via Message (SIP) –You may fill in the Video phone number here, it will inform the Video Phone when the
Figure 21 : Extension Number