Item Brochure

For detailed specications and ordering go to amprobe.com 6003703 CAmprobe

| info@amprobe.com | Fluke Corporation, Everett, WA 98203 | Tel: 877-AMPROBE (267-7623)

Hot Stick attachment

The optional TIC 410A Hot Stick accessory enables easier

tracing of wires in high ceilings, walls and along oors.

TIC 410A

Hot Stick Attachment

AT-7000 Features and Functions

Trace Wires Inside Conduit

Trace energized and de-energized wires enclosed in metal

conduit by removing the junction box cover and using the

AT-7000-R Receiver’s Tip Sensor to identify the specic wire

carrying the transmitted signal generated by the AT-7000-T

Transmitter. Wires in non-metal conduit can be traced

directly without opening the junction box and using the

AT-7000-R Receiver’s Smart Sensor

™

Trace energized wires without access

to exposed conductors

The SC-7000 signal clamp accessory can be used with the

AT-7000-T Transmitter to induce a signal into energized

and de-energized wires when there is no access to bare

conductors. Simply clamp around the desired wire to

induce the signal, then begin tracing.

Use the Tip Sensor to trace wires in

hard to reach areas

When used with the AT-7000-T Transmitter, the Tip Sensor

pinpoints the location of energized and de-energized wires

in tight, hard to reach spaces. It easily and accurately traces

the targeted energized and de-energized wires in junction

boxes, corners, walls, oors and ceilings to a depth of up to

20 feet.

Non-contact voltage (NCV) detection

The NCV feature extends functionality of the AT-7000-R

Receiver by detecting energized wires from 90 to 600

V and 40 to 400 Hz without the use of the AT-7000-T

Transmitter. Its adjustable sensitivity ts a range of

applications, from detecting presence of voltage (higher

sensitivity) to precisely pinpointing a hot wire in a bundle

(lower sensitivity).

Trace energized or de-energized wires by removing the junction

box cover.

Use the Tip Sensor to trace wires in hard to reach areas.

Induce signal with the signal clamp when there is no bare conductor.

Non-contact voltage (NCV) detection.

Trace wires in hard to reach places with the TIC 410A.