Specifications

Chapter 4 BIOS Setup
ReadyBoard 800 Reference Manual 69
Panel Type – [None]
Refer to Table 4-3 for the list of supported resolutions and flat panel types. Some LCD panels
may require video BIOS modifications. It you think this is the case, or would like help in
setting up your LCD panel, contact Ampro for assistance with the LCD panel adaptation.
Table 4-3. LCD Panel Type List
# LCD Resolution LCD Type # LCD Resolution LCD Type
None NA
8
1 640 x 480 x 18 (bit) LVDS 9
2 800 x 600 x 18 (bit) LVDS 10
3 1024 x 768 x 24 (bit) LVDS 11
4 1280 x 1024 x 18 (bit) LVDS 12
5 1400 x 1050 x 18 (bit) LVDS 13
6 1024 x 768 x 18 (bit) LVDS 14
7 1600 x 1200 x 18 (bit) LVDS 15
PCI, Plug n' Play, and Interrupt/DMA Assignments
PCI
INTA IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
INTB IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
INTC IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
INTD IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
INTE IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
INTF IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
INTH IRQ – [none], [1], [3], [4], [5], [6], [7], [9], [10], [11], [12], [14], or [15]
Plug and Play
PnP BIOS – [Disabled] or [Enabled]
* If this field is set to [Enabled], the BIOS uses Plug and Play adapter initialization and
assigns the resources, such as I/O addresses, IRQs, and DMA channels to Plug and Play
compatible devices. The resources assigned by the BIOS are based on the settings of the
IRQ and DMA channel assignments listed in the following fields.
* If this field is set to [Disabled], the IRQs and DMA channels listed below will not be
assigned to Plug and Play devices by the BIOS.
PnP OS – [Disabled] or [Enabled]
If this field is set to [Enabled], the BIOS makes the Plug and Play API available for Plug
and Play Operating Systems. This allows the Plug and Play OS to get the Plug and Play
information by calling the Plug and Play API.
Assign IRQ 1 – [Disabled] or [Enabled]
* If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play adapter.
* If another device in the system is using this IRQ, then this field should be set to [Disabled].
Assign IRQ 3 – [Disabled] or [Enabled] (Typically COM2)
* If this field is set to [Enabled], then the BIOS can assign this IRQ to a Plug and Play adapter.
* If another device in the system is using this IRQ, then this field should be set to [Disabled].