Specifications

Chapter 2 Product Overview
8 Reference Manual ReadyBoard 800
Provides 16550-equivalent controllers, each with a built-in 16-byte FIFO buffer
Supports full modem capability on three of the four ports
Supports RS-232 operation on all four ports
Supports RS-485 or RS-422 operation on two ports, Serial 3 & 4 (COM3 & COM4)
Supports programmable word length, stop bits, and parity
Supports 16-bit programmable baud-rate generator
USB Ports
Provides two root USB hubs
Provides four USB ports
Provides two standard USB connectors (USB 0 & 1) and one 10-pin header (USB 2 & 3)
Supports USB v2.0 and legacy v1.1 devices
Supports one USB floppy disk drive
Provides over-current shared fuses on board
Audio interface
Supports AC’97 audio standard
Provides AC’97 CODEC
Provides non-amplified Stereo Line In/Out
Provides non-amplified MIC in (Mono)
Ethernet Interfaces
Provides two fully independent Ethernet (RJ45) ports
Provides Intel’s 82551ER and 825541GI (Gigabit) Ethernet controllers
Provides integrated LEDs on each port (Link/Activity and Speed)
Supports IEEE 802.3 10BaseT/100BaseTX compatible physical layer
Supports IEEE 802.3x 10BaseT/100BaseTX/1000BaseT compatible physical layer
Supports Auto-negotiation for speed, duplex mode, and flow control
Supports full duplex or half-duplex mode
Full-duplex mode supports transmit and receive frames simultaneously
Supports IEEE 802.3x Flow control in full duplex mode
Half-duplex mode supports enhance proprietary collision reduction mode
Video Interfaces (CRT/LVDS)
Support CRT (1600 x 1200) with 64 MB UMA (Unified Memory Architecture)
Provides standard 15-pin VGA connector
Provides AGP 4X equivalent performance
Provides LVDS outputs (1 or 2 channels; four differential signal pairs; two 12-bit interleaved
or one 24-bit non-interleaved) on 30-pin header
Infrared Interface
Provides IrDA v1.1 signals on separate connector (J9)
Supports HPSIR and ASKIR infrared modes
Supports IR mode select from the Super I/O chip