Specifications

Chapter 4 BIOS Setup Utility
76 Reference Manual ReadyBoard 800
∗ Example [HDD: Mfg, model]
• 4
th
Boot Device – [1
st
Floppy Drive], [HDD: Mfg + model], [CD/DVD], [Network:IBA xE Slo], or
[Disabled]
∗ Example [Network:IBA xE Slo] (onboard Ethernet 2 connection)
Changing Boot Order (Swap) Example:
1. Scroll to the 1
st
Boot Device [1
st
Floppy Drive] and press the <Enter> key.
The Options list appears with all of the detected devices listed including [Disabled] as an
option. Only the 1
st
Drive selections from the device types (Hard Disk, Removable, and
CD/DVD) will be shown in the popup menu. See Figure 4-5.
If you want to change from a standard floppy drive to a USB floppy drive, go to the Removable
Drives list, where you can select the device that appears in the list instead of the 1
st
Floppy Drive.
Options
1st Floppy Drive
HDD: Mfg, Model
Network: IBA GE Slot 01xx vxxx
Disabled
CD/DVD: Mfg, Model
Figure 4-5. Boot Options Popup Menu Example
2. Scroll down the popup menu list and select another device, such as the CD-ROM in the 2
nd
Boot
Device position and press the <Enter> key.
The CD-ROM changes or swaps place with the 1
st
Floppy Drive, while at the same time putting
the 1
st
Floppy Drive in the 2
nd
Boot Device position (former location of the CD-ROM).
3. If you select [Disabled], the 1
st
Floppy Drive moves to the 4
th
position (last), and changes to
Disabled, while all other devices move up in the Boot order.
The following device type fields are dependent on the type and number of devices connected to the
system. For example, you may not see the CD/DVD type field if there are no CD-ROMs or DVDs
connected to the system, including USB CD/DVDs.
>Hard Disk Drives
This option specifies the boot sequence from the available Hard Disk Drives (HDD). This option
and the number of HDDs only appears on screen if the BIOS detects Hard Disk Drives (HDD)
attached to the system, including USB HDDs.
• 1
st
Drive – [HDD: Mfg + Model], [HDD: Mfg + Model], or [Disabled]
The 1
st
Drive in this list is the only device to appear in the Boot Device Priority list. The remaining
fields are dependent on the number of HDD devices detected by the BIOS, including the compact
flash card. Use the swap example described earlier when changing the order of these devices.
• 2
nd
Drive – [HDD: Mfg + Model], [HDD: Mfg + Model], [HDD: Mfg + Model], or [Disabled]
• 3
rd
Drive – [HDD: Mfg + Model], [HDD: Mfg + Model], [HDD: Mfg + Model], or [Disabled]
>Removable Drives
This option specifies the boot sequence from the available Removable Drives. The number and
type of devices only appear on screen if the BIOS detects more than one Removable Drive
attached to the system, including USB floppy drives, Zip drives, etc.
• 1
st
Drive – [1
st
Floppy Drive], [USB: Mfg + model or device type],
[USB: Mfg + model or device type], or [Disabled]