Specifications

Chapter 4 BIOS Setup Utility
ReadyBoard 800 Reference Manual 69
♦ Redirection After BIOS POST – [Disabled], [Boot Loader], or [Always]
♦ Terminal Type – [ANSI], [VT100], or [VT-UTF8]
∗ If [VT-UTF8] is selected, the following item disappears from the screen.
• VT-UTF8 Combo Key Support – [Disabled] or [Enabled]
♦ Sredir Memory Display Delay – [No Delay], [Delay 1 sec], [Delay 2 sec] or [Delay 4 sec]
∗ If [Delay 4 sec] is selected,
>USB Configuration
Depending on the USB devices detected, examples similar to those listed below may be displayed.
Module Version - x.xx.xx-xx.x Or Module Version - x.xx.xx-xx.x
USB Devices Enabled: USB Devices Enabled:
2 drives None:
• USB Function – [Disabled], [2 USB ports], or [4 USB ports]
• Legacy USB Support – [Disabled], [Enabled], or [Auto]
This field supports the USB mouse and USB keyboard when no USB drivers are loaded for the
operating system (OS). If this option is not enabled, the attached USB mouse and USB keyboard
will not be available until a USB compatible OS is fully booted with all the USB drivers loaded.
NOTE If this field is not enabled with [Enabled] or [Auto] the USB mouse
and USB keyboard will not be recognized by the BIOS until the OS
is fully booted and the USB drivers are loaded.
∗ If [Enabled] is selected, USB devices may be used during boot time and while using DOS.
∗ If [Auto] is selected, USB devices like, a USB keyboard or USB mouse will be automatically
detected and if found, will be initialized and utilized during Boot time.
• USB 2.0 Controller – [Enabled] or [Disabled]
∗ If [Disabled] is selected, the following item disappears from the screen.
♦ USB 2.0 Controller Mode – [Full Speed] or [Hi Speed]
This field configures the USB 2.0 controller for [Full Speed = 12 Mbps] or
[Hi Speed = 480 Mbps]
• BIOS EHCI Hand-Off – [Disabled] or [Enabled]
This field is used as work around for operating systems (OSs) that do not have EHCI hand-off
support. The EHCI ownership change should be claimed by the EHCI driver.
>USB MASS Storage Device Configuration
• USB Mass Storage Reset Delay – [10 sec], [20 sec], [30 sec], or [40 sec]
This field determines the number of seconds POST waits for the storage device after the start unit
command is sent.
♦ Device #1 – [Mfg + model or device type]
♦ Emulation Type – [Auto], [Floppy], [Forced FDD], [Hard Disk], or [CDROM]
This field emulates USB device types.
∗ If this field is set to [Auto] it will emulate USB devices less than 530 MB as Floppy and
devices larger than 530 MB as Hard Drives.
∗ If the [Forced FDD] options is selected, a HDD formatted drive can be forced to boot as
FDD (except ZIP drives).