Specifications

Chapter 4 BIOS Setup Utility
68 Reference Manual ReadyBoard 800
>Hardware Health Configuration
• H/W Health Function – [Disabled] or [Enabled]
Hardware Health Event Monitoring
♦ System Temperature [Current board temperature in °C/°F]
♦ CPU Temperature [Current CPU die temperature in °C/°F]
♦ VcoreA [Current CPU Core A reading]
♦ VcoreB [Current CPU Core B reading]
♦ +3.3Vin [Current +3.3 voltage reading]
♦ +5Vin [Current +5 voltage reading]
♦ +12Vin [Current +12 voltage reading]
♦ -12Vin [Invalid voltage readings]
♦ -5Vin [Invalid voltage readings]
♦ +5VSBin [Current +5 standby voltage reading]
>ACPI Configuration
• Advanced ACPI Configuration
♦ ACPI 2.0 Features – [No] or [Yes]
∗ If [Yes] is selected, the BIOS will support the ACPI 2.0 specifications.
♦ Headless Mode – [Disabled] or [Enabled]
∗ If [Enabled] is selected, the ACPI FSDT (Fixed System Description Table) is updated to
indicate headless operation mode through ACPI. Today, headless operation implies no
keyboard or mouse.
• Chipset ACPI Configuration
♦ APIC ACPI SCI IRQ – [Disabled] or [Enabled]
>MPS Configuration
• MPS Revision – [1.1] or [1.4]
>Smbios Configuration
• Smbios Smi Support – [Disabled] or [Enabled]
>Remote Access Configuration
• Remote Access – [Hotcable] or [Enabled]
This field enables the Remote Access (Serial Console or Console Redirection) features.
♦ Serial Port Number – [COM1] or [COM2]
Base Address, IRQ [3F8h, 4]
♦ Serial Port Mode – [115200, 8, n, 1], [57600, 8, n, 1], [38400, 8, n, 1], [19200, 8, n, 1], or
[09600, 8, n, 1]
∗ If [57600, 8, n, 1] is selected, the remote access operates at 57.6 kHz baud rate and there
are 8 start bits, no parity, and 1 stop bit used.
♦ Flow Control – [None], [Hardware], or [Software]
∗ If [Hardware] is selected, flow control is handled by hardware.
∗ If [Software] is selected, flow control is handled by software.