Specifications

ReadyBoard 800 Reference Manual 1
Chapter 1 About This Manual
Purpose of this Manual
This manual is for designers of systems based on the ReadyBoard™ 800 single board computer (SBC).
This manual contains information that permits designers to create an embedded system based on specific
design requirements.
Information provided in this reference manual includes:
• ReadyBoard 800 Specifications
• Environmental requirements
• Major integrated circuits (chips) and features implemented
• ReadyBoard 800 connector/pin numbers and definition
• BIOS Setup Utility information
Information not provided in this reference manual includes:
• Detailed chip specifications
• Internal component operation
• Internal registers or signal operations
• Bus or signal timing for industry standard busses and signals
Reference Material
The following list of reference materials may be helpful for you to complete your design successfully.
Most of this reference material is also available on the Ampro web site in the Embedded Design
Resource Center. The Embedded Design Resource Center was created for embedded system developers
to share Ampro’s knowledge, insight, and expertise gained from years of experience.
Specifications
• EPIC Specification Revision 1.0, March 22, 2004
Web site: http://www.ampro.com/RP/EPIC_Specification_v1.0.pdf
• PC/104™ Specification Revision 2.5, November 2003
• PC/104-Plus™ Specification Revision 2.0, November 2003
• PCI-104™ Specification Revision 1.0, November 2003
For latest revision of the PC/104, PC/104-Plus, and PCI-104 specifications, contact the PC/104
Consortium, at:
Web site: http://www.pc104.org
• PCI™ 2.3 Specifications
For latest revision of the PCI specifications, contact the PCI Special Interest Group Office at:
Web site: http://www.pcisig.com
• Compact Flash Specifications Revision 3.0, December 2004
For the latest revision of the compact flash specifications, contact the Compact Flash association at:
Web site: http://www.CompactFlash.org