Specifications

Chapter 2 Product Overview
ReadyBoard 800 Reference Manual 17
Specifications
Physical Specifications
Table 2-9 lists the physical dimensions of the board. Figures 2-9 and 2-10 give the mounting
dimensions, including side views, and Figure 2-9 shows the pin-1 connector locations.
Table 2-9. Weight and Footprint Dimensions
Parameter Dimensions
Weight 0.117 kg. (0.26 lb.)
Height (overall) 28.44 mm (1.12")
Width 115 mm (4.5")
Length 165 mm (6.5")
PCB Thickness 1.574 mm (0.062")
NOTE Overall height is measured from the upper
board surface to the highest permanent
component (at Serial A) on the upper
board surface. This measurement does
not include the heatsinks available for
these boards. See Figure 2-10.
Power Specifications
Table 2-10 lists the ReadyBoard 800 power requirements.
Table 2-10. Power Supply Requirements
Parameter
Model
Input Type In-rush* Current BIT** Current
800 MHz ULV
Celeron M
Regulated DC voltages +5.0V @ 16.12A Typical 3.31A (16.54W)
1.0 GHz ULV
Celeron M
Regulated DC voltages +5.0V @ 16.1A Typical 3.51A (17.55W)
1.4 GHz LV
Pentium M
Regulated DC voltages +5.0V @ 16.2A Typical 3.72A (18.58W)
1.8 GHz
Pentium M
Regulated DC voltages +5.0V @ 14.16A Typical 3.95A (19.77W)
Notes: *In-rush measured with video, 128 MB memory, and power connected. Typically, in-rush
current reflects the short duration current spike associated with charging large on-board bulk
capacitance during power supply start up. However, the listed in-rush current value is the result of
placing a switch on the DC output of a fully 'ramped' power supply to give a worst-case current
value, which is much higher than the standard method. This in-rush value should be regarded as a
maximum design guideline, not a requisite value.
**The BIT (burn in test) is conducted with 128 MB DDR SODIMM, floppy (1), IDE HDD (1), USB
HDD (1), USB CD-ROM (1), keyboard, mouse, serial loopbacks (4), USB compact flash reader (1)
and one card (64 MB), USB Thumb drive (1), and active Ethernet channels (2) in a Windows® XP
OS environment.