Specifications

Chapter 2 Installing ReadyBoard 700 Options
ReadyBoard 700 QuickStart Guide 19
7. Insert the CompactFlash card into the socket provided by the tabs on the protective cover as
shown in Figure 2-1.
The CompactFlash card edges and the socket are keyed to install in only one orientation.
RB700_06a
Insert CompactFlash Card
CompactFlash Socket (J23)
Pin-1 Marker
Keyed Slot (2)
Lip or
Catch Edge
ReadyBoard 700
(Bottom view)
Figure 2-4. Installing the CompactFlash Card
8. Push the CompactFlash card into the socket until it is firmly into the socket and mates with the
pins. See Figures 2-4 and 2-5.
9. Turn the ReadyBoard 700 back over onto the bottom of the board, placing it on the work surface.
10. Reconnect any cables you disconnected earlier and verify all other connections to the
ReadyBoard 700 are still connected.
11. Set the Master/Slave jumper (JP4) to the master/salve status before continuing. See Table 2-1
and Figure 1-4.
Table 2-1. CompactFlash Jumper Setting
Jumper # Installed Removed/Replaced
JP4 – CF Master/Slave Master (pins 1-2) Default Slave (removed)
12. Plug the ATX power supply’s power cord into the AC power source and restore power.
13. Go into the BIOS Setup Utility and change the settings for the CompactFlash Card placing it in
the Drive Assignment and the Boot Order.
NOTE The CompactFlash must be listed in Drive Assignment and the Boot
Order to be recognized by the BIOS. The CompactFlash can be listed
in any of the drive positions.
However, the BIOS does not support a break in the drive order, that is,
Drive C can not be listed as [none] when the boot device is Drive D.