Specifications

Chapter 1 Setting Up the ReadyBoard 700
ReadyBoard 700 QuickStart Guide 11
NOTE The ReadyBoard 700 ships from the factory configured for CRT support
only. Ampro provides LVDS/LCD/TFT support for flat panels with
specific resolutions.
If you have questions about the flat panels, contact Technical Support
through Virtual Technician (http://ampro.custhelp.com) for help in setting
up the flat panel configurations. Refer also to the ReadyBoard 700
Reference Manual and the Software Release Notes for additional
instructions and information when customizing the BIOS to a particular flat
panel.
Table 1-1. Jumper Settings
Jumper # Installed Removed/Installed
JP1 – TFT/LCD Clock Clock Invert (pins 1-2) Clock (pins 2-3) Default
JP2 – LCD Voltage Type Enable +3.3V (pins 1-2) Default Enable +5V (pins 2-3)
JP3 – CMOS Normal/Clear Normal (pins 1-2) Default Clears Time & Date only (pins 2-3)
JP4 – CF Master/Slave Master (pins 1-2) Default Slave (removed)
JP5 – Flash BIOS Internal (pins 1-2) Default External (removed)
JP6 – COM3 RS485 Termination (pins 1-2) No Termination (removed) Default
JP6 – COM4 RS485 Termination (pins 3-4) No Termination (removed) Default
NOTE The CMOS Normal/Clear jumper (JP3) only resets the Time and Date
of the BIOS to Jan 1, 1980; 00:00. If you need to reset the BIOS to
the defaults because you can’t boot the system, use the Oops! Jumper
referenced in the ReadyBoard 700 Reference Manual. The Oops!
Jumper prevents the current BIOS settings in Flash memory from
being loaded, forcing the BIOS to use the default settings, but does not
change the Time & Date in the BIOS. The ReadyBoard 700
Reference Manual provides a more detailed discussion of how to
create and use the Oops! Jumper.