Specifications

Chapter 1 Setting Up the ReadyBoard 700
ReadyBoard 700 QuickStart Guide 7
8) Connect USB 2 & 3 Cable
Assembly
• Connect the USB 2 & 3 cable assembly to J21 on the edge of the
ReadyBoard 700 as shown in Figure 1-6.
Refer also to Figures 1-1, 1-4.
9) Connect Utility Cable
Assembly
• Connect the Utility cable assembly to J18 near the edge of the
ReadyBoard 700 as shown in Figure 1-6.
Refer also to Figures 1-1 and 1-4.
♦ The Green Power-On switch uses Pins-1 & -2 of the Utility
Connector.
♦ The Red Reset switch uses Pins-2 and -3 of the Utility
Connector.
NOTE The Power-On switch turns the ReadyBoard 700 to an On condition,
if your are using an ATX power supply. Normally, the operating
system (OS) will turn Off the ReadyBoard during the OS shut down
process. However, if you need to turn off the ReadyBoard, pressing
and holding the Power-On button for more than 4-6 seconds will turn
the ReadyBoard 700 to an Off state.
RB700_09a
Connect USB 2 & 3
Cable Assembly to J21
Connect Utility Cable
Assembly to J18
Note: Keyboard/Mouse connector
shown removed for clarity.
Figure 1-6. Connecting the Utility and USB Cable Assemblies