Specifications

Chapter 1 Setting Up the ReadyBoard 700
6 QuickStart Guide ReadyBoard 700
Skip any of the following steps that do not apply to your situation.
6) Connect the Audio In/Out
Cable Assembly
• Connect the Audio In/Out cable assembly to J19 near the edge of
the ReadyBoard 700 as shown in Figure 1-5.
Refer also to Figures 1-1, 1-4.
The Earphone connector on the Audio cable assembly is not
connected on the ReadyBoard 700.
7) Connect the ATX Adapter
Cable Assembly
• Connect the ATX Power Adapter cable assembly to J4 and J6 on
the edge of the ReadyBoard 700 as shown in Figure 1-5.
Refer also to Figures 1-1, 1-4.
The ATX power adapter is separated into two connectors to
provide support for non-ATX power supplies (Power Input (J4)
and Power Control (J6)).
Connector (J4) only provides the input voltages (+5V & optional
+12V) and ground, while connector (J6) provides the power on
signal and the standby voltage (+5V).
• If you do not use an ATX power supply, you will have to provide
the standby voltage (+5V) to J6 for the soft off function.
Typically, this means shorting the +5V (pin-1, J4) to J6, pin-1.
RB700_08a
Connect the ATX Power Adapter
Cable Assembly to J4 and J6
Connect the Audio In/Out
Cable Assembly to J19
J4
J6
J19
Note: The PS/2 Keyboard/Mouse
connector is shown removed
for clarity.
Figure 1-5. Connecting Audio In/Out and ATX Power Adapter Cable Assemblies