Specifications

Chapter 2 Installing LittleBoard 550 Options
LittleBoard 550 QuickStart Guide 13
CompacFlash Socket (J23)
CompactFlash Card
Protective Cover
(Do not remove)
LittleBoard 550
LB550QSG_03d
Figure 2-2. CompactFlash Card Installed
Removing the CompactFlash Card
1. If the LittleBoard 550 SBC is already powered up, power down the system.
CAUTION To prevent damage to the LittleBoard 550 or the CompactFlash, ensure the
power supply is turned off and the power cord has been removed from the power
source. The typical AT power supply will continue to provide standby current
to the chassis until the power cord is disconnected.
2. Disconnect the power cord from the power source.
CAUTION To prevent damage to the LittleBoard 550 or the CompactFlash card, do not
touch either one until you have discharged yourself and have followed good
Electrostatic Discharge principals. The LittleBoard 550 and CompactFlash
cards are sensitive to static electricity and can be easily damaged by improper
handling. Do the following when handling the CompactFlash cards:
Leave the CompactFlash in the anti-static bag until you are ready to install it.
Always use an anti-static wrist/ankle strap and a grounding mat connected to
ground.
Before you remove a CompactFlash card from the anti-static bag, touch a
grounded, unpainted metal surface to discharge any static electricity.
3. Insert a small to medium flat blade screwdriver into the slot as shown in Figure 2-3.