Specifications

Chapter 3 Installing ReadyBox Options
ReadyBox Users Guide 25
7. Connect the sharp curved portion of the IDE cable onto the IDE connector on the board, matching
pin-1 on the board/connector with the Red stripe of the IDE cable. See Figure 3-10.
NOTE You can feed the curved portion up through the cable feed opening
in the enclosure shelf near the IDE connector, or you can feed the
folded portion down through the cable feed opening before
connecting the IDE cable. Either way, it is your choice!
Refer to the ReadyBoard’s Reference Manual or QuickStart Guide for connector and pin
locations.
8. Feed the free end of the IDE cable with the folded section out of the enclosure through the HDD
tray opening. See Figure 3-10.
Sharp Curve for
ReadyBoard
Connector
Right Angle or
90 Fold
°
Double Folds
Recommended
(Not required)
To IDE HDD (2 ½”)
Red Stripe
(Pin-1)
RdyBox_IDEcable
Figure 3-9. Folding the IDE Cable
RdyBox_13c
IDE Cable
IDE Connector
Red Stripe (Pin-1)
Hard Disk Drive (2 ½”)
Cable Fold
Cable Feed Opening
Figure 3-10. Attaching the IDE Cable